[_private/calc1_ahdr.htm]

Re: Friden 130 top cover removal

From: Bill Layer
Email:

Comments

Actually. that is not correct, as I have discovered. The machine does not need to be turned over, but just have a couple inches of the rear hanging over a table edge. There are two screws in the extreme rear corners, one on each side. These are captive screws, and need to be loosened until they drop down, but do not actually fall out of the case. Once the two screws are loose, the cover can be slid forward about 1/2 inch, then lifted up slightly, and slid off toward the front.

[_private/calc1_aftr.htm]